Wooden box production process

First, the purchased plates are processed into plates of the same thickness, the surface should be smooth, then the patterned sawing plate is cut, and the splicing is done with ordinary white latex. Then fix it, and after a day it dries.

Secondly, the treated wood needs to be polished, and then put on the putty. After a day, it needs to be polished. If it is not flat, it must be polished again. It must be smooth because it depends on the smoothness and smoothness of the paint. The last is to apply the primer, after a day of sanding, you can use water sandpaper, starting at 600, and then paint and then sand more than 600 until it feels smooth. Finally brush the top coat, thin and even. It will be finished in a week.

Finally, some nice patterns can be painted on the wooden box. If you have special requirements, you will also need to make a pattern plate. Soak the prepared pattern in water for a few seconds, take it out and stick it on the wooden box directly as required, and then hang the water inside with a scraper. After less than 10 hours, gently peel off the top layer of plastic film and cover it with a top coat.